cardot share car alarm installation information

I can not push start car engine when install cardot smart car alarm to my car?

I can not push start car engine when install cardot smart car alarm to my car?

  • Sunday, 24 December 2017
  • 0
  • 629
  • 0

I can not push start car engine when install cardot smart car alarm to my car?

answer you  as follows:

1. please make sure that you have connected correct ACC wire,ON1 wire,ON2 wire,Start wire.

2.how to find above wires exactly?watch this video:


3. you connected footbrake wire? or you hold the button for more than 2 seconds?

4.you avoided chip key immobilizer?

5. you misplaced installation between ON1 and ON2?cardot ON1 to your car ON2,cardot ON2 to your car ON1?

6.you connected cardot blue fuel path wire if you enabled fuel path mode by dip2 setting(valid set when button light is ON)?

7.Your car is diesel mode,you have not set diesel mode by DIP1(valid set when button light is ON)?

8.Weather is too cold,you hold the button for more than 4 seconds?

9.Smart key battery is enough? or Smart key is away from the car?

10.There is strong signal interference around the car´╝č

11.Start Stop button is broken?

12.Car Alarm Main Unit has defection?contact us to confirm this if you have tried above all possible methods.


0 users like this.

Leave a Reply